Product: Stone Spray-N-Seal®
- Surface should be dry for 6-12 hours before sealing.
- Clean countertop surface using Marbamist or Clean EnCounters. For stone floors, clean with Marbalex. (It is safe to lightly clean the stone before sealing.)
- Cover surrounding areas that are not intended to be sealed.
- Liberally spray the entire surface until it is wet. (Outer edges may dry quicker.)
- When surface begins to dry within 3-5 minutes, wet the surface again with the sealer. (This will allow the sealer to properly penetrate and cure.)
- After 30 minutes, wipes off excess sealer from the surface with a clean and dry white terry cloth towel.
- If excess dries on the surface, spray more sealer onto the surface and wipe off immediately with a clean dry terry cloth towel. For large stone floors, excess can be buffed off with a clean white buffing pad or an all cloth bonnet pad.
|
