Cleaning Shower Walls

PRODUCTS NEEDED: USE: USAGE:
Marbalex® Stone Floor Cleaner Daily/Weekly
Ceramiclean® Tile & Grout Cleaner Daily/Weekly
Stone Spray-N-Seal® Stone & Grout Sealer Yearly
Counterrific™ Stone & Tile Disinfectant As Needed
Grout Ink™ Restores the color of grout As Needed

 

 

CLEANING STONE SHOWERWALLS: (Daily to Weekly)
Product: Marbalex®
  1. Dry/Dust mop the floor at least twice per week.
  2. Pour 2 ounces of Marbalex into a clean bucket of water.
    (Be sure that the bucket has been thoroughly cleaned out if it has been used before with another cleaner.)
  3. Using a clean rayon sponge, gently apply the Marbalex on to the surface without making large puddles.
  4. Let the surface dry. There is no rinsing required.

 

CLEANING TILE & GROUT SHOWERWALLS: (Daily-Weekly)
Product: Ceramiclean®
  1. Remove all abrasive debris from the floor surface.
  2. Mix 1-2 ounces of Ceramiclean per gallon of warm water.
  3. With a clean bucket and clean rayon or sponge mop, apply the Ceramiclean to the surface.
  4. Let the solution dry.
  5. Rinsing is only required for heavily soiled surfaces
SEALING: (Every 1-2 years)
Product: Stone Spray-N-Seal®
  1. Surface must be dry for 6-12 Hours.
  2. Cover surrounding areas that are not intended to be sealed.
  3. Liberally spray the surface until it is wet.
  4. When the surface begins to dry within 3-5 minutes, wet the surface again with the sealer.
  5. After 30 minutes, wipe off any excess sealer with a clean and dry white terry cloth or towel.

 

 

POLISHING & ENRICHING COLOR: (Monthly)
Product: International Stone Polish®
  1. Shake the bottle before using and apply the polish to the stone surface with a clean, dry and white terry cloth towel.
  2. Let the polish dry to a haze for 2 minutes.
  3. Wipe off the haze with a clean, dry and white terry cloth towel.
    * Do not use on floors.
DISINFECTING: (Weekly)
Product: Counterrific™
  1. Simply spray Counterrific on to the surface and let it stay wet for five minutes.
  2. Wipe off with a clean and dry paper towel.
  3. If any streaks appear, simply spray again and wipe off immediately.
RESTORING THE COLOR OF GROUT: (As Needed)
Product: Grout Ink™
  1. Ensure surface is free from grease, dirt and other contaminants.
  2. Shake well with cap on before use. Remove cap, and then press pen down vertically for a minute until you see the ink starting to flow.
  3. Apply two (2) coats an hour apart.
  4. Replace cap when not in use. * If grout is dirty, clean with SCI's Ceramiclean® before using the Grout Ink.
    * 4. Note: Ink colors may appear slightly different from the color of the pen caps.

 

15% OFF Stone & Grout Sealers

 

Featured Products

Tile & Grout Care Kit

Sue's Helpful Hints By SCI's Tech Support Specialist

Check out Sue's Helpful Hints section where she shares with you her expert advice, favorite products, tips and reccommendations.

Read Sue's Hints