|
|
 |
Cleaning Shower Walls
| CLEANING STONE SHOWERWALLS: (Daily to Weekly) |
Product: Marbalex®
- Dry/Dust mop the floor at least twice per week.
- Pour 2 ounces of Marbalex into a clean bucket of water.
(Be sure that the bucket has been thoroughly cleaned out if it has been used before with another cleaner.)
- Using a clean rayon sponge, gently apply the Marbalex on to the surface without making large puddles.
- Let the surface dry. There is no rinsing required.
|
| CLEANING TILE & GROUT SHOWERWALLS: (Daily-Weekly) |
Product: Ceramiclean®
- Remove all abrasive debris from the floor surface.
- Mix 1-2 ounces of Ceramiclean per gallon of warm water.
- With a clean bucket and clean rayon or sponge mop, apply the Ceramiclean to the surface.
- Let the solution dry.
- Rinsing is only required for heavily soiled surfaces
|
| SEALING: (Every 1-2 years) |
Product: Stone Spray-N-Seal®
- Surface must be dry for 6-12 Hours.
- Cover surrounding areas that are not intended to be sealed.
- Liberally spray the surface until it is wet.
- When the surface begins to dry within 3-5 minutes, wet the surface again with the sealer.
- After 30 minutes, wipe off any excess sealer with a clean and dry white terry cloth or towel.
|
| POLISHING & ENRICHING COLOR: (Monthly) |
Product: International Stone Polish®
- Shake the bottle before using and apply the polish to the stone surface with a clean, dry and white terry cloth towel.
- Let the polish dry to a haze for 2 minutes.
- Wipe off the haze with a clean, dry and white terry cloth towel.
* Do not use on floors.
|
| DISINFECTING: (Weekly) |
Product: Counterrific™
- Simply spray Counterrific on to the surface and let it stay wet for five minutes.
- Wipe off with a clean and dry paper towel.
- If any streaks appear, simply spray again and wipe off immediately.
|
| RESTORING THE COLOR OF GROUT: (As Needed) |
Product: Grout Ink™
- Ensure surface is free from grease, dirt and other contaminants.
- Shake well with cap on before use. Remove cap, and then press pen down vertically for a minute until you see the ink starting to flow.
- Apply two (2) coats an hour apart.
- Replace cap when not in use. * If grout is dirty, clean with SCI's Ceramiclean® before using the Grout Ink.
* 4. Note: Ink colors may appear slightly different from the color of the pen caps.
|
|
|
|
|
|
